U1200 Engine Trouble Code
Meaning of U1200 engine trouble code is a kind of network trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.
U1200 Fault Symptoms :
|
If one of these reasons for U1200 code is occuring now you should check U1200 repair processes.
Now don't ask yourself; What should you do with U1200 code ? The solution is here : |
U1200 Possible Solution:
Power Steering Pressure (PSP) Switch Malfunction In Key On, Engine Off Self-Test, this DTC indicates the PSP input to the PCM is high. In Key On, Engine Running Self-Test, this DTC indicates that the PSP input did not change state. Steering wheel must be turned during Key On, Engine Running Self-Test PSP switch/shorting bar damaged SIG RTN circuit open PSP circuit open or shorted to SIGRTN PCM damaged. |
U1200 Code Meaning :
U | 1 | 2 | 0 | 0 |
---|---|---|---|---|
OBD-II Diagnostic Network (U) Trouble Code For Engine | Fuel And Air Metering | Manifold Absolute Pressure/Barometric Pressure Circuit High Input | Cold Start Injector 1 Malfunction | Shift Solenoid E Performance or Stuck Off |
The poor running symptoms are consistent with a MAP sensor malfunction. In addition, in some cases, a bad MAP sensor will not throw a code. Again, the ELD code likely represents a separate wiring issue.
U1200 OBD-II Diagnostic Network (U) Trouble Code DescriptionU1200 engine trouble code is about Shift Solenoid E Performance or Stuck Off.Main reason For U1200 CodeThe reason of U1200 OBD-II Engine Trouble Code is Manifold Absolute Pressure/Barometric Pressure Circuit High Input. |
U1200 DTC specifically refers to the camshaft (cam) timing. In this case, if the cam timing is over-retarded, the engine light will be illluminated and the code will be set.